NuPAGE Gels

A gel electrophoresis system used for SDS-PAGE protein analysis. The gels are made up of Bis-Tris-HCl (pH 6.4) polyacrylamide and are intended for denaturing conditions only.

NuPAGE Electrophoresis Protocols

1) Remove gel from pouch and rinse gel with D.I. water holding the gel by the edges of the cassette. (Gels should be stored at 4o C)

2) Mark the bottom of the lanes with a permanent marker.

3) Peel off tape from the bottom of the cassette.

4) ｉｎｓｅｒｔ gel into the Mini-Cell so that you can read "10 % BIS-TRIS" when facing the gel. If only running one gel use the square plastic dam to ｒｅｐｌａｃｅ the second gel cassette.

5) Check for tightness of the seal by filling the inner chamber with a small amount of buffer. If a leak is detected reposition or reassemble the chamber.

6) Remove the comb from the gel. Using a disposable needle tip, remove any residual buffer from the wells.

7) Proceed to fill the inner chamber with running buffer so that the buffer level covers the level of the wells. If running reduced samples add .5 mL of NuPAGE Anti-oxidant.

8) Load samples onto gel and pour running buffer into the outer chamber until it covers about half of the cassette.

9) Run gels according to the protocol which is applicable:

10% Bis-Tris Gel with MES Running Buffer Voltage: 200V constant Expected Current: Start: 110-125 mA per gel; End: 70-80 mA per gel Approx. Run Time: 35 minutes 10% Bis-Tris Gel with MOPS Running Buffer Voltage: 200 V constant Expected Current: Start: 110-115 mA per gel; End: 60-70 mA per gel Approx. Run Time: 50 minutes 4-12% Bis-Tris Gel with MES Running Buffer Voltage: 200V constant Expected Current: Start: 110-125 mA per gel; End: 70-80 mA per gel Approx. Run Time: 35 minutes 4-12% Bis-Tris Gel with MOPS Running Buffer Voltage: 200V constant Expected Current: Start: 110-115 mA per gel; End 70-80 mA per gel Approx. Run Time: 50 minutes 10) When gel is complete, shut off power, disconnect electrodes and remove gel from Mini-Cell 11) Separate each of the three bonded sides by prying them open with a screw driver. Using a razor blade cut the sides of the gel. The thick edge at the bottom of the gel should be cut off.

Sample Preparation

1) Prepare sample buffer by mixing 50 μL of NuPAGE Sample Buffer, 30 μL D.I. water, and 20μL of reducing agent. (Reducing agent can be either 0.5 M DTT in stabilized liquid form or beta-mercaptoethanol)

2) Add sample buffer in a 1:1 ratio to sample

3) Heat mixture of sample buffer and sample for 5 minutes in boiling water bath.

4) Heat See-Blue standard for 3 minutes in boiling water bath.